Table of Contents
Advertisement
6
Thermostat Installer Options
The installer options can be accessed by pressing and holding the
Option 01 for setting the
(See Installer Options Chart)
Press or hold the
NEXT
Option 01.
Press the
ENTER
key to save all options in non-volatile memory.
If only one wireless thermostat and damper control module are used in an application, the thermostat can be left with the
factory default setting of Zone = 01
If multiple wireless thermostats and damper control modules are used that are less than 500 feet away from one another,
each thermostat must be set to a different
off the subbase and in easy access of its damper control module.
7
Setting the Zone Number
If more than one WZ1 is used in the same application, each thermostat and module must be assigned a different
communications address. Use the
maximum number that can be used in the same building is eight
Zone
Option
CANCEL
NEXT
Press the
NEXT
key to advance to the next option. Press the
8
Heating Setpoint Limit
Press the
NEXT
key to select
set maximum allowable heating setpoint.
The maximum heating setpoint range is 60 to 85F.
Zone
number.
key to advance to the next option. The LCD will advance through to Option 09 and then return to
Zone
UP
and
DOWN
ENTER
Option 08
and press the
ENTER
number. For convenience, set the Installer Options with the thermostat
keys to set the zone number for each thermostat in the system.
.
ENTER
key if no more options are to be changed.
Up
or
Down
key to
4
key for seven seconds. The LCD displays
Installer Options Chart
Option
Description
01
Zone number
Range
01 to 08
Default
01
Program damper module to Zone address
03
Default 01
08
Maximum allowable heating setpoint
Range
60 to 85F
Default
76F
09
Minimum allowable cooling setpoint
Range
55 to 80F
Default
68F
Option
CANCEL
The
Heat
Set To
NEXT
ENTER
Advertisement
Table of Contents
