Wireless Zone One™ Module
1
Installation
The Wireless Zone One™ damper control module comes installed on the zone damper and is completely factory wired.
The damper control module is powered by a separate 24 Volt, 40 VA transformer.
Wireless Zone One™ Thermostat
2
Location
The thermostat should be located in the area being controlled by the zone damper and away from the HVAC unit
thermostat. Do not install the thermostat in an area where drafts are present, near the floor, behind doors or on an
external wall. Avoid placing the thermsotat in areas where the air movement is limited, affected by direct sunlight or other
areas not typical of the temperature in the space.
24 VAC
PROGRAM
ENABLE
LED
BUTTON
G Y W R C
Solid Red LED = Heat Call
Solid Yellow LED = Cool Call
Flashing Green LED = No Calls
DAMPER
ACTUATOR
PO / SC
GREEN
LED
1
2 3 4
5 6
DUCT SENSOR
2
ON WHEN DAMPER
IS POWERED OPEN
7