OPERATION OF WIRELESS REMOTE CONTROLLER
CHANGING BATTERIES AND ADDITIONAL NOTES
To change batteries, slide cover off battery compartment on back of remote controller. Remove
and safely discard old batteries. Insert two new AAA 1.5V dry batteries, using correct polarity.
Reattach back cover.
NOTE:
• If the remote controller will not be used for a long time, remove batteries to prevent
leakage damage.
• Be sure to aim the remote controller at the receiver of the main unit when operating.
.
• When remote emits a signal, icon will flicker; a tone will be heard when unit receives
that signal.
CHANGING BATTERIES
Remove
old batteries
EMERGENCY OPERATION
Use the Manual Override button to manual operate the unit if the remote controller is lost or
damaged. Lift up the front panel section on the indoor unit and locate the Manual Override
button on the right hand side. Press the Manual Override button to turn ON the unit.The unit
will operate in AUTO mode and will automatically select heating or cooling to maintain room
temperature between 68°F and 77°F. The indoor fan will operate in auto fan mode. Press the
Manual Override button to cancel Manual Override Mode and transfer control back to the
remote controller.
.
Install
new batteries
Manual
Switch
21