Selecting Operating Mode And Key Features - Gree Terra GWH09TB-D3DNA1A Owner's Manual

SELECTING OPERATING MODE AND KEY FEATURES

MODE BUTTON
Use the "MODE" button to select one of the available modes.
The selected mode will be displayed on the remote controller
and the appropriate light will illuminate on the display panel.
AUTO – Unit will automatically select heating or cooling
to maintain room temperature between 68°F and 77°F.
The remote controller will display the Auto Mode icon with
no setpoint.The front panel display will show "77. "
COOL – To cool to selected setpoint and remove moisture. System
varies compressor speed to maintain desired temperature.
HEAT – To heat to selected room setpoint. System varies
compressor speed to maintain desired room temperature.
FAN ONLY – To circulate air without heating or cooling.
Use Fan Speed button to select speed from low to ultra high.
DRY – Select DRY MODE to increase moisture removal during
warm humid conditions.
1. Room Temperature > Setpoint +4°F, the system will be
operating in cooling mode with low fan speed.
2. Setpoint -4°F, < Room Temperature < Setpoint +4°F, the
system will cycle 6 minutes ON and 4 minutes OFF in
cooling mode.The indoor fan will be at low speed.
3. Room Temperature < Setpoint -4°F, the system will be OFF
and the indoor fan will be at low speed.
TURBO MODE
The desired setpoint, either in heating or cooling, can be achieved
faster if TURBO mode is used. After selecting the"HEAT" or
"COOL" mode button, push the "TURBO" button.The TURBO
icon will be displayed on the remote controller and the unit
will run at ultra high speed fan.To deactivate the feature, push the
"TURBO" button again.The unit will return to normal operation.
X-FAN MODE
When operating in humid areas,Terra has a DRY COIL function
called X-Fan that will allow the indoor fan to run for a pre-determined
amount of time after the unit is turned off (cooling or dry modes)
to ensure that additional moisture is removed from coil. Push the
"X-FAN" button to enable this feature. The X-FAN
will be displayed on remote controller. To deactivate this
feature, push the "X-FAN" button again.
Icons Displayed
Turbo Mode Display
X-Fan Mode Display
icon
: AUTO
: COOL
: DRY
: FAN ONLY
: HEAT
12