Rds Af Setting (Radio Data System: Alternative Frequencies) (Factory Default: Disabled); Delete All Bluetooth Pairing Information; Exit Voice Configuration Menu - Sena SPH10H-FM User Manual

SPH10H-FM
9.6 RDS AF setting (Radio Data System: Alternative
Frequencies) (Factory Default: Disabled)
Voice Prompt
Factory Default
Enable
Disable
RDS AF allows a receiver to re-tune to a different frequency
providing the same station has an additional frequency. In
RDS AF, the receiver will "re-tune" to the second frequency
location when the first signal becomes too weak. With RDS
AF enabled on the receiver, a radio station with more than
one frequency can be used.
Note:
RDS feature may be available when radio channel station
provides equivalent service.
22
"RDS AF setting"
Disable
Tap the Phone Button
Tap the Jog Dial

9.7 Delete All Bluetooth Pairing Information

Voice Prompt
Factory Default
Execute
To delete all Bluetooth pairing information of the
SPH10H, rotate the Jog Dial until you hear a voice
prompt, "Delete all pairings", and tap the Phone Button
to confirm. Taping the Jog Dial is not available for this
setting.
9.8 Exit Voice Configuration Menu
Voice Prompt
Factory Default
Enable
To exit voice configuration menu and get back to stand-
by mode, rotate the Jog Dial until you hear a voice
prompt, "Exit configuration", and tap the Phone Button
to confirm. Taping the Jog Dial is not available for this
setting.
"Delete all pairings"
N/A
Tap the Phone Button
"Exit configuration"
N/A
Tap the Phone Button