Bluetooth Gps Navigation Pairing - Sena SPH10H-FM User Manual

2. If you have a stand alone Bluetooth stereo device,
follow the pairing procedure separately. The procedure
is the same as the procedure in "6.1 Mobile Phone
Pairing".
Note:
1. If Bluetooth connection between the headset and a
mobile phone is disconnected, tap the Phone Button to
recover the Bluetooth connection immediately.
2. If Bluetooth connection between the headset and a
media player is disconnected, press the Jog Dial for 1
second to recover the Bluetooth connection and play.

6.4 Bluetooth GPS Navigation Pairing

You can listen to voice instruction from Bluetooth GPS
navigation. Some GPS systems use mobile phone profile
(HFP, Hands-Free Profile) and others use stereo music
profile (A2DP, Advanced Audio Distribution Profile). Most
motorcycle specific GPS systems use mobile phone profile
for turn-by-turn voice instruction. You can simultaneously
use a mobile phone and a GPS which uses mobile phone
profile by one of the following procedures.
6.4.1 Multipoint GPS Pairing
If you use GPS only for turn-by-turn voice instructions,
not for Bluetooth stereo music streaming, multipoint
pairing is recommended for the GPS connection.
Multipoint Bluetooth pairing allows the SPH10H-FM
to connect two HFP devices at the same time: mobile
phone and GPS navigation. Follow the steps below to
pair the GPS using the multipoint pairing.
1. Turn on the headset and press the Jog Dial for 5
seconds until the red LED is rapidly flashing and you
hear multiple beeps.
2. Within 2 seconds, tap the Phone Button again, then
the LED turns to blue flashing and the beeps turn to
high tone double beeps. You will hear a voice prompt
saying "Multipoint pairing".
3. Search for Bluetooth devices on the GPS navigation
screen. Select the Sena SPH10H-FM in the list of the
devices detected on the GPS.
4. Enter 0000 for the PIN.
5. The GPS confirms that pairing has completed and
the SPH10H-FM is ready to use. You will hear a voice
prompt from the SPH10H-FM saying "Your headset
is paired".
6. If the pairing process is not completed within three
minutes, the SPH10H-FM will return to stand-by mode.
SPH10H-FM
13