Table of Contents
Advertisement
For Existing Hard Drives with Data
1.
As the BIOS boots press Ctrl+S or F4 when prompted to enter
the RAID BIOS.
2.
At the next screen select Create RAID Set, then press Enter.
3.
At the next screen select Mirrored then press Enter.
4.
Select Manual configuration, then press Enter.
5.
Select the Source drive, press Enter.
6.
Select the Target drive, press Enter.
7.
Enable Disk Copy, select Yes, then press Enter.
Note: Enable Disk Copy – Copy current content of source driver to
mirror drive; Disable Disk Copy – RAID 1 set formed must be
repartitioned and reformatted to guarantee the consistency in their
contents.
8.
Press Ctrl+E to exit the BIOS.
9.
When asked Are you sure to exit(Y/N)?, press Y to exit and
reboot.
Note: If during boot the RAID BIOS reports an RAID1 set is in
Rebuild status, The rebuild will continue after boot sequence is
complete, disregard the message, continue booting, and let the Mirror
rebuild.
MN2000000107
Page 9
Advertisement
Table of Contents
