Table of Contents
Advertisement
For Windows® Vista-x64
For New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents of
the "
PCI_IO\Sata\64-bit Windows RAID Driver" folder, found on the
driver CD, onto a blank floppy disk then follow the directions below.
1.
Setup the RAID Array prior to Windows installation.
2.
Follow Microsoft's Windows installation procedure.
3.
At the Windows Setup screen, press Load Driver to install the
RAID driver.
4.
Insert the floppy disk, please select Silicon Image SiI 3512
SATARaid Controller (A:\si3112r.inf), then press Next. (Change
A:\ to match your floppy drive letter)
5.
Follow the on-screen instructions to complete the Windows
installation.
For An Existing Installation
1.
Setup the RAID Array prior to driver installation and boot up to
Windows.
2.
At Found New Hardware Wizard, select Locate and install
MN2000000107
Page 18
Advertisement
Table of Contents
