Table of Contents
Advertisement
on-screen instructions to complete the Windows installation.
For An Existing Installation
1.
Setup the RAID Array prior to driver installation and boot up to
Windows.
2.
At Found New Hardware Wizard, click Next.
3.
Select Search for a suitable driver for my device(recommend)
then click Next.
4.
Insert the driver CD, check CD-ROM drives, uncheck the other
boxes, click Next, then click Next again.
5.
If the Digital Signature Not Found message appears, click Yes.
Our driver has been thoroughly tested for stability and
compatibility.
6.
Click Finish.
For Windows® XP/Server 2003
For New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents of
the "
PCI_IO\Sata\RAID" folder, found on the driver CD, onto a
MN2000000107
Page 13
Advertisement
Table of Contents
