Table of Contents
Advertisement
this time, then click Next.
3.
Insert the driver CD, select Install the software automatically
(Recommended), and click Next.
4.
Click Finish.
For Windows®XP-x64/Server 2003-x64
For New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents of
the "
PCI_IO\Sata\64-bit Windows RAID Driver" folder, found on the
driver CD, onto a blank floppy disk then follow the directions below.
1.
Setup the RAID Array prior to Windows installation.
2.
Follow Microsoft's Windows installation procedure.
3.
At the Windows Setup screen, press F6 to install the RAID driver.
4.
When prompted, press S to specify the location of the driver.
5.
Inset the floppy disk, then press Enter.
6.
Select Silicon Image SiI 3x12 SATARaid Controller (64-bit
Extended) or Silicon Image SiI 3x12 SATARaid Controller
(Itanium), then press Enter.
7.
Press Enter to finish driver installation, then follow the on-screen
MN2000000107
Page 15
Advertisement
Table of Contents
