Table of Contents
Advertisement
3.
At the Windows Setup screen, press Load Driver to install the
RAID driver.
4.
Insert the floppy disk, please select Silicon Image SiI 3512
SATARaid Controller (A:\si3112r.inf), then press Next. (Change
A:\ to match your floppy drive letter)
5.
Follow the on-screen instructions to complete the Windows
installation.
For An Existing Installation
1.
Setup the RAID Array prior to driver installation and boot up to
Windows.
2.
At Found New Hardware Wizard, select Locate and install
driver software (recommended).
3.
Please insert the CD driver bound with SATA 150 PCI RAID card
into your CD-ROM Drive, click Next.
4.
If the system prompts the user informing the drivers are not
signed, select the option Install this driver software anyway.
5.
Click Close to complete the installation.
MN2000000107
Page 17
Advertisement
Table of Contents
