Table of Contents
Advertisement
your system starts up. If the BIOS doesn't show, please try your
controller in another PCI slot. During this (POST) process, the BIOS
will show up and indicate the devices attached to it.
Driver Installation
For Windows® 2000
For A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents of
the "
PCI_IO\Sata\RAID" folder, found on the driver CD, onto a
blank floppy disk then follow the directions below.
1.
Setup the RAID Array prior to Windows installation.
2.
Follow Windows® 2000 installation procedure.
3.
At the Windows® 2000 Setup screen, press F6 to install the RAID
driver.
4.
When prompted, press S to specify the location of the driver.
5.
Insert the floppy disk, then press Enter.
6.
Select Silicon Image SiI 3x12 SATARAID Controller for
Windows NT 4.0 and 2000, then press Enter.
7.
Press Enter again to finish driver installation, then follow the
MN2000000107
Page 12
Advertisement
Table of Contents
