Table of Contents
Advertisement
blank floppy disk then follow the directions below.
1.
Setup the RAID Array prior to Windows installation.
2.
Follow Microsoft's Windows installation procedure.
3.
At the Windows Setup screen, press F6 to install the RAID driver.
4.
When prompted, press S to specify the location of the driver.
5.
Insert the floppy disk, then press Enter.
6.
Select Silicon Image SiI 3x12 SATARaid Controller for
Windows XP/Server 2003, then press Enter.
7.
Press Enter to finish driver installation, then follow the on-screen
instructions to complete the Windows installation.
Note: If the Security Alert warning pops up, click Yes. Our driver has
passed Microsoft compatibility testing, this message appears during
new installation.
For An Existing Installation
1.
Setup the RAID Array prior to driver installation and boot up to
Windows.
2.
At the Found New Hardware Wizard:
XP(w/SP1 or earlier)/Server 2003: continue to step #3
XP(w/SP2 or later)/Server 2003(w/SP1 or later): select No, not
MN2000000107
Page 14
Advertisement
Table of Contents
