Installing Cpu And Heat Sink - Advantech MIC-3369C User Manual

Modern integrated electronic devices, especially CPUs and memory
chips, are extremely sensitive to static electric discharges and fields. Keep
the card in its antistatic packaging when it is not installed in the PC, and
place it on a static dissipative mat when you are working with it. Wear a
grounding wrist strap for continuous protection.

1.7 Installing CPU and Heat Sink

The MIC-3369C supports the Intel Pentium M processor. In order to meet
critical environmental conditions and the physical space of the MIC-
3369C at the same time, Advantech has designed a heatsink to fulfill its
primary needs. Please refer to Figure 1-4 for an illustration of the heatsink
used for the MIC-3369C.
The small aluminum plate is default fastened on the CPU in the factory.
When installing the memory, the following steps should be followed:
1. Remove the screws from the solder side cover. At this step, the
front panel will also be loose. Be careful about any improper disassemble
procedure that could cause any damage to the SBC.
2. Remove the rest four screws for heatsink standing, then the heat-
sink is loose for memory installation and relavant.
3. Follow the opposite procedure to assemble the heatsink and solder
side cover.
Note:
MIC-3369C User's Manual
The heat pad is sealed between heatsink and
CPU and is fragile, so please be careful during
the disassembly procedure. Any damage to the
heat pad will allow heat leakage.
22