Table of Contents
Advertisement
Appendix C
Easy Entry™ User's Guide
This section of the user's guide provides information on using the Security Command
system Easy Entry™ access control capability. If
™
your system is not currently using any access control devices, disregard this section. The keypad displays for All/Perimeter or Home/Away
operation are dependent on how your keypad was programmed by your alarm dealer. Easy Entry™ is built into every Security Command
™
system and can be accessed using Easy Entry™ keypads.
There are three different operating modes: Door Strike, Arming and Disarming, and Entry Delay. All of the examples below assume that
your system requires a user code to arm and disarm the protection.
DOOR STRIKE
ABC SECURITY
Area and All/Perimeter Door Strike — From the Status List, present your card to the
MON
10:20 AM
reader. When the card is validated by the system, the Door Strike relay activates for
5 seconds during which time you can open the door. Once you open the door, you
have 40 seconds to exit and close the door before the Zone 2 Soft-Shunt expires.
Home/Away systems only activate the Door Strike relay when arming and
disarming.
ARMING AND DISARMING AN AREA SYSTEM
Press COMMAND, the keypad displays
ABC SECURITY
ABC SECURITY
ABC SECURITY
ARM
DISARM?.
Press the Select
ALL?
NO
YES
ENTER CODE: –
ARM
DISARM
key under either option. The keypad
displays ENTER CODE: -.
Present your card to the reader. Once
the system validates the card, all
areas accessible by you arm or disarm
automatically and the Door Strike relay
activates.
38
XR20 User's Guide
Appendix
Advertisement
Table of Contents
