Table of Contents
Advertisement
Numeric Pager Display
00 128- 3012340010
Account
Message
Always
Number
ID
Zero
Account Number
This number is programmed into your Security Command™
system as an identifier. Whenever the system sends a
message to your pager, it always sends the account number
first to identify itself.
Message ID
This is always a single digit that describes the message.
1 = Zone Alarm
2 = Zone Trouble
3 = Area(s) Arming
4 = Area(s) Disarming
Zone or Area Number
If this message is for a zone, the 1 to 2-digit zone number
displays.
If this message is for areas being armed or disarmed, the
area numbers display in sequential order. Example: 1 2 4.
User Number
This is a 3-digit number that identifies the user.
Area
Always
User
Number
Zero
Number
5 = Late to Close
6 = User Check-in
7 = Local Message
Cut along dotted lines.
1. Call the panel phone number. The panel answers and sounds one
short tone.
2. Enter your code within eight seconds. One beep means the code
is good. Four short beeps means enter it again. You have three
tries.
3. You have 30 seconds to enter the first command (see other side) and
30 seconds for each additional command.
If
All areas are armed
Area 1 (Perimeter) is armed
Any area is armed
All areas are disarmed
1. Call the panel phone number. The panel answers and sounds one
short tone.
2. Enter your code within eight seconds. One beep means the code
is good. Four short beeps means enter it again. You have three
tries.
3. You have 30 seconds to enter the first command (see other side) and
30 seconds for each additional command.
If
All areas are armed
Area 1 (Perimeter) is armed
Any area is armed
All areas are disarmed
You will hear
3 short beeps
1 short beep
2 short beeps
1 long beep
You will hear
3 short beeps
1 short beep
2 short beeps
1 long beep
Advertisement
Table of Contents
