System expansions
Installing/removing hard disk drive with screws
This chapter only applies to the SCENIC Edition X100.
i
On the SCENIC Edition X100 the hard disk drive can only be mounted in the second bay
with screws.
Removing a hard disk drive
►
Open the casing (see "Opening the casing").
►
Unscrew the four screws (1) on the drive cage.
►
Pull the second hard disk drive out of the casing in the direction of the arrow (2).
►
Disconnect all cables connected to the drive (data cable, power supply cable).
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
►
Connect the cables to the hard disk drive.
►
Close the casing (see "Closing the casing").
44
A26361-K678-Z121-1-7619, edition 1