No Mouse Pointer Displayed On The Screen; The Floppy Disk Cannot Be Read Or Written - Fujitsu Siemens Computers SCENIC Edition X100 Operating Manual

Professional pc
Hide thumbs Also See for SCENIC Edition X100:
Table of Contents

Advertisement

Wrong monitor has been set under Window XP
Restart the PC.
Press F8 while the system is booting.
Either the Windows Advanced Start Options menu or the menu for selecting the operating system
appears.
If the menu for selecting the operating system appears, press F8 .
Select Safe Mode or Safe Mode with Network.
Set the correct values for the attached monitor as described in the operating manual of the
monitor by selecting Start - Settings - Control Panel - Display and then the Appearance, Themes,
Settings tabs.
The wrong RAM modules have been inserted
See the technical manual for the mainboard for information on which memory modules can be used.

No mouse pointer displayed on the screen

Shut down the operating system properly.
Switch the PC off.
Check that the mouse cable is properly connected to the system unit.
If you use an adapter or extension lead with the mouse cable, check the connections.
Make sure that only one mouse is connected.
Switch the PC on.
The mouse controller must be enabled if you use a PS/2 mouse on the PS/2 mouse port
Check in the BIOS Setup that the mouse controller is Enabled.
Check that the mouse driver is properly installed and is present when the application
programme is started. Detailed information can be found in the user guide for the mouse and
application programme.

The floppy disk cannot be read or written

Check that the write protection of the floppy disk or the floppy disk drive is activated (refer to
the "BIOS Setup" manual and if necessary to the technical manual for the mainboard).
Check the entry for Diskette A: in the Main menu of the BIOS Setup.
Check that the floppy disk drive controller is enabled (refer to the "BIOS Setup" manual and if
necessary to the technical manual for the mainboard).
Check that the cables of the floppy disk drive are properly connected (refer to "Replacing the
floppy disk drive" chapter).
A26361-K678-Z121-1-7619, edition 1
Troubleshooting and tips
.
29

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SCENIC Edition X100 and is the answer not in the manual?

This manual is also suitable for:

Scenic edition x102Esprimo edition p

Table of Contents