►
Connect the cables to the hard disk drive.
►
Close the casing (see "Closing the casing").
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
Installing a hard disk drive
►
Open the casing (see "Opening the casing").
►
Take the new hard disk drive out of its packaging.
►
Make the required settings (e.g. master/slave, cable select) on the drives.
►
Disconnect all connected cables (data cable, power supply) from any drives already installed.
►
Unscrew the two screws (1) on the drive cage.
►
Pull the drive cage upward (2) out of the casing.
►
Slide the hard disk drive into the drive cage.
4
►
Tighten the new hard disk drive on the drive cage with four screws (4).
►
Push the drive cage into the bracket (5) of the casing again.
►
Mount the drive cage with the two screws (6).
►
Connect the cables to the hard disk drive.
A26361-K678-Z121-1-7619, edition 1
1
2
4
System expansions
3
6
5
47