Installing And Removing The Battery Pack - Focus FS-4/ User Manual

Reels Screen (FS-4Pro only) - allows selected clips to be marked for
placement in particular Reels Folders.

Installing and Removing the Battery Pack

Before operating the FS-4, install the battery as follows:
Step 1: Turn the FS-4 unit over, so that the back is facing you as
shown in the following illustration.
Step 2: Slide the battery pack into the compartment. Make sure
the contacts on the side meet the contacts on the inside
of the unit.
Step 3: Make sure the battery latch clicks into place.
You can immediately use the FS-4 unit if you attach the AC power
cord with or without the battery pack installed.
You must charge the battery until the battery status LED indicates the
unit is charged before you can use the FS-4 with the battery. The
Charge LED on the top of the FS-4 lights to show the battery is charg-
ing. A flat battery on charge will take 2-3 hours to charge with the unit
powered off.
The included battery will supply power to the FS-4 for about 90 min-
utes while in continuous Record or Playback mode.
Battery Latch
Battery
Compartment
11