Driving Off; Idle Mode; Valet Mode; Ignition Valet - Autostart AS-1414 User Manual

Windshield Wipers, Radio and Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are off. Leaving the headlight switch
ON on certain types of vehicles could cause them to remain on even after the remote starter
shuts down, resulting in a dead battery.

Driving Off

With the vehicle running under remote control, press the
the doors (if installed). Enter the vehicle and do the following:
•
Turn the ignition key to the
•
Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Caution: do not turn the key to the
the starter motor to re-engage, unless your vehicle is equipped with the start kill / anti-
grind feature (optional).

Idle Mode

This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
programmed run time, or until it is shut down by remote.
Caution: Do not leave children or pets unattended in a car running in idle mode.
To activate Idle Mode:
To enable idle mode, press and hold the
transmitter while the engine is running.
Note: When enabling idle mode, pressing
doors.
The parking lights will come on. Remove the key, exit the vehicle and lock the doors (if
desired). The engine will continue running and will turn itself off when the pre-programmed
run time expires.

Valet Mode

Ignition Valet

The system can be placed in valet mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, valet mode will prevent the engine from
being accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the ignition switch, turn the key to the ON
OFF positions 5 times within 10 seconds.
2. The parking light will flash 3 times indicating the module is now in valet mode. The
LED will turn
To EXIT Valet Mode
1. With the key in the ignition switch, turn the key to the ON
OFF positions 5 times within 10 seconds.
2. The parking light will flash twice indicating the module is now out of valet mode.
The led will turn OFF.
AS-1414/ AS-1424 User Guide
IGNITION ON (RUN)
CRANK
IGNITION
LOCK
solid.
ON
UNLOCK
position.
position with the engine running. This will cause
switch. The vehicle will keep running for the pre-
, or
UNLOCK START/STOP
or will automatically unlock the
LOCK UNLOCK
button to and
DISARM
button on your remote
and then
(RUN/IGNITION)
and then
(RUN/IGNITION)
UNLOCK
P. 3