Table of Contents
Advertisement
Page: 43
Service Guide OKIPAGE4w
Chapter 3 Parts Replacement
Separator Guide
(1) Remove the upper cover assy. (See Upper Cover Assy in this Chapter).
(2) Remove the high-voltage power supply board. (See High-Voltage Power Supply Board in this
Chapter).
(3) Remove five screws 1.
(4) Remove inlet 2 from base frame 3.
Removing inlet 2
Insert a screwdriver into the hole on the side of base frame 3, remove the inlet claw from base frame 8,
and remove inlet 2.
(5) Disconnect three cables 4 and connector 11 and remove base frame 3. Then, remove screw 10
and disconnect FG cable 12.
Disconnecting connector 11
Remove connector 11 by drawing it upward while pushing the clamp lever with a standard screwdriver.
(6) Remove the paper holder assy. (See Paper Holder in this Chapter).
(7) Remove two engagements and sheet guide 5.
(8) Remove friction pad 6, compression spring S7, and separator guide 8.
(9) Remove paper sensor E9.
Advertisement
Table of Contents
