Sartorius Master series User Manual page 72

Over/Under Checkweighing with Additional Requirements
Changing the Tolerance Limits
You can change the over/under tolerances between 0.1% and 10%.
Tolerance limits
0.1% over/under deviation from the target
0.2% over/under deviation from the target
0.5% over/under deviation from the target
1.0% over/under deviation from the target
1.5% over/under deviation from the target
2.0% over/under deviation from the target
2.5% over/under deviation from the target
3.0% over/under deviation from the target
5.0% over/under deviation from the target
10.0% over/under deviation from the target
Analog Display
You can use an analog marker (two segments) instead of the bar graph located
below the checkweighing indication.
Analog display
Off
Bar graph
Analog marker
Automatic Data Output
"Acceptable" values can be printed out or transferred automatically. Data are
output once the readout has stabilized within the tolerance limits selected.
Following data output, this function will be blocked until the balance has been
completely unloaded.
Automatic data output
On
Off
* = factory setting
4–12
Code
4 1 1
4 1 2
4 1 3
* 4 1 4
4 1 5
4 1 6
4 1 7
4 1 8
4 1 9
4 1 10
Code
8 5 1
* 8 5 2
8 5 3
Code
4 2 1
* 4 2 2