Sartorius Master series User Manual page 68

Weighing in Percent with Additional Requirements
Changing the Reference Percentage
You can change the reference percentage to meet your individual requirements.
The reference percentage setting will be displayed above the unit symbol after you
press c.
To select the change function: Hold down i for more than 2 seconds
To change the setting:
To store the percentage:
Note: This setting is not canceled by the reset code 9 – –1
Changing the reference percentage
No change
In cycles: 5, 10, 20, 50, 100, 5, 10, ...
In increments of one
Storage Parameter for the Reference Weight
The reference weight is stored
with full accuracy according to the internal resolution
according to the display accuracy
Display Parameter for Readouts in Percent
The readout in percent is displayed
without a decimal place
with one decimal place
with two decimal places
with three decimal places
Use in Combination with Other Programs
Program
Tare memory
Over/under checkweighing (net weight)
Over/under checkweighing (difference in weight)
* = factory setting
4–8
Use f identified by – ^ –
If you enter a wrong number, press c to clear it.
– temporarily until you turn off the power: briefly
press F
– p ermanently after you turn off the power (in the non-
volatile memory): press F for more than 2 seconds
o
.
Code
2 3
* 2 3
2 3
Code
3 5
* 3 5
Code
3 6
* 3 6
3 6
3 6
Code
2 2
2 2
2 2
1
2
3
1
2
1
2
3
4
2
3
4