Table of Contents
Advertisement
SUPERSERVER 6026TT-HD/D6 Series User's Manual
Note: The SuperServer 6026TT-HD/D6 series system is cableless and does not
need or come with SATA/SAS cables.
1-2
Serverboard Features
At the heart of the SuperServer 6026TT are four X8DTT-HF+/X8DTT-HIBXF+/
X8DTT-HIBQF+ dual processor serverboards, which are based on Intel's 5520
(North Bridge) + ICH10R (South Bridge) chipset. Below are the main features of
the serverboards. Note that the features on each board are doubled for the server,
which includes two nodes.
Processors
Each X8DTT-HF+/X8DTT-HIBXF+/X8DTT-HIBQF+ supports two Intel® 5600/5500
Series processors in LGA1366 sockets. Please refer to our web site for a complete
listing of supported processors (www.supermicro.com).
Memory
Each X8DTT-HF+/X8DTT-HIBXF+/X8DTT-HIBQF+ has twelve DIMM sockets that
can support up to 192 GB of registered ECC DDR3-1333/1066/800 SDRAM, or 48
GB of unbuffered non-ECC 1333/1066/800 SDRAM. See Chapter 5 Section 6 for
more details on installing memory into the system.
Serial ATA
The South Bridge (ICH10R) of the chipset includes a Serial ATA controller for six
Gb/s SATA drives. The hot-swappable SATA drives are connected to a backplane
that provides power, bus termination and confi guration settings. RAID 0, 1, 10 and
5 are supported. Refer to the support area of our web site for procedures on set-
ting up RAID on your system.
SAS
The D6 series servers (6026TT-D6RF/D6IBXRF/D6IBQRF) include a daughter
card with an LSI 2108 SAS controller in rach node, which supports six SAS 2.0
ports (12 ports for the system). The hot-swappable SAS drives are connected to a
backplane that provides power, bus termination and confi guration settings.
1-2
Advertisement
Table of Contents
