Table of Contents
Advertisement
Figure 6-3. Removing a Dummy Drive Tray
1
Figure 6-4. Mounting a Hard Drive in a Carrier
Hard Drive
2
1
Drive Carrier
Installing/Removing Hot-swap Drives
1.
To remove a carrier, push the release button located beside the drive LEDs.
2.
Swing the handle fully out and use it to pull the unit straight out (see Figure
6-5). See the following pages for the logical layout of the hot-swap drives.
Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the
!
Supermicro Web site at http://www.supermicro.com/products/nfo/storage.
cfm
1
2
1
6-5
Chapter 6: Advanced Chassis Setup
1
1
Advertisement
Table of Contents
