5-10 Sata And Sas Ports - Supero 6026TT-HDTRF User Manual

SUPERSERVER 6026TT-HD/D6 Series User's Manual
BMC Activity LED (LE2)
A BMC Heartbeat LED is located at LE2
on the motherboard. When LE2 is on,
BMC (Baseboard Management Controller)
is active. See the table at right for more
information.
HDD/SATA LED (LE3)
An HDD/SATA LED is located at LE3 on the
motherboard. This LED indicates the status
of hard drive activitiy or SATA activity sup-
ported by the South Bridge.
Rear UID LED (LE4)
The Rear UID LED is located at LE4 on
the motherboard. Refer to Section 5-7 for
details.

5-10 SATA and SAS Ports

SATA Connections
A Front Panel Add-On Card header is located
at JF2 on the motherboard. This header
provide onboard SATA support. Plug an
add-on card in JF2 to use SATA connections.
These connections provide serial-link signal
transmission, which is faster than that of the
traditional Parallel ATA.
SAS Connections
SAS is supported on the 6026TT-D6 series of
servers only with the addition of pre-installed
daughter cards. These cards include an LSI
2108 SAS controller for SAS support.
BMC Heartbeat LED
On BMC is normal
HDD/SATA LED
Status
On HDD/SATA
Connected
Off No connection
5-18
(LE3)
Defi nition