Table of Contents
Advertisement
Installing the Air Shroud
Air shrouds concentrate airfl ow to maximize fan effi ciency. The SC111 chassis air
shroud does not require screws to set up. See Figure 6-3.
Air Shroud Installation
1.
Align the air shroud over the motherboard and behind the system fans.
2.
Gently place the air shroud in your chassis with the front side touching the
edges of the fans.
6-4
Drive Bay Installation/Removal
Accessing the Drive Bays
Hard Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace hard drives.
Proceed to the next section for instructions.
DVD-ROM Drive: For installing/removing a DVD-ROM drive, you will need to gain
access to the inside of the system by removing the top cover of the chassis. Proceed
to the "DVD-ROM Drive Installation" section later in this chapter for instructions.
Note: Only a "slim" DVD-ROM drive will fi t into the 1017C-TF.
Hard Drive Installation
The hard drives are mounted in drive carriers to simplify their installation and
removal from the chassis. These carriers also help promote proper airfl ow for
the drive bays. For this reason, even empty carriers without drives installed must
remain in the chassis.
Installing a Hard Drive into a Drive Carrier (Figure 6-3)
1.
Remove the dummy drive, which comes pre-installed in the drive carrier, by
removing the screws securing the dummy drive to the carrier. Note that these
screws cannot be reused on the actual 2.5" hard drive.
Chapter 6: Advanced Chassis Setup
6-5
Advertisement
Table of Contents
