Control Panel Leds; Universal Information Led - Supero 1017C-TF User Manual

S S
UPER ERVER 1017C-TF User's Manual
3-3

Control Panel LEDs

The control panel located on the front of the SC111LT chassis has fi ve LEDs. These
LEDs provide you with critical information related to different parts of the system.
This section explains what each LED indicates when illuminated and any corrective
action you may need to take.

Universal Information LED

When this LED blinks red quickly, it indicates a fan failure and when blinking red
slowly a power failure. This LED will be blue when used for UID (Unit Identifi er).
When on continuously it indicates an overheat condition, which may be caused by
cables obstructing the airfl ow in the system or the ambient room temperature being
too warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers
are installed. Finally, verify that the heatsinks are installed properly (see Chapter
5). This LED will remain fl ashing or on as long as the indicated condition exists.
See the table below for descriptions of the LED states.
Figure 3-1. Universal Information LED States
State
Fast Blinking Red (1x/sec)
Solid Red
Slow Blinking Red (1x/4 sec)
Solid Blue
Blinking Blue
Note: deactivating the UID LED must be performed in the same way it was activated.
(If the UID LED was activated via IPMI, you can only turn the LED off via IPMI and
not with the UID button.)
Universal Information LED States
Indication
Fan Fail
CPU Overheat
Power Fail
Local UID Button Depressed
IPMI-Activated UID
3-2