Installing Memory - Supero 1017C-TF User Manual

S S
UPER ERVER 1017C-TF User's Manual
5-5

Installing Memory

Note: Check the Supermicro web site for recommended memory modules.
Exercise extreme care when installing or removing DIMM modules
Installing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with slots
DIMM1A. Pay attention to the notch along the bottom of the module to pre-
vent inserting the DIMM module incorrectly. See Figure 5-5.
2. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat fstep 1 to install to DIMM1B if needed.
Memory Support
The X9SCL-F supports up to 32GB of ECC unbuffered (UDIMM) DDR3-1333/1066
memory in four memory slots. Populating these slots with a pair of memory mod-
ules of the same type and same size will result in interleaved memory, which will
improve memory performance. Please refer to the table below:.
DIMM Slots
per Channel Populated per
2
2
Slot 2, Channel 2
(Blue Slot)
Slot 2, Channel 1
Slot 1, Channel 2
(Blue Slot)
Slot 1, Channel 1
CAUTION
to prevent any possible damage.
DDR3 Unbuffered ECC (UDIMM) Memory
DIMMs DIMM Type
Channel
1 Unbuffered
DDR3
2 Unbuffered
DDR3
POR Speeds
1066, 1333
1066, 1333
5-8
Ranks per DIMM
(any combination)
Single Rank, Dual
Rank
Single Rank, Dual
Rank