9.6 Running Diagnostics
The LI6BM comes with a diskette containing a diagnostic software
supporting the Intel 82558B Ethernet controller. Follow the steps below
to use the Setup Utility.
1. Run the file
SETUP.EXE
your floppy disk drive is drive A. Upon doing so, the system starts the
and shows the following screen.
Setup Utility
8255x-based PCI EtherExpress™ adapter Setup V4.16
Automatic setup
View adapter configuration
Test adapter
Install network drivers
View Help files
Exit Setup
Choose AUTOMATIC SETUP to view the adapter's configuration, make sure it
works properly, and install the software needed to connect to your network.
Select = ↑↓
Help = F1 Exit = Esc
2. Selecting
View adapter configuration
8255x-based PCI EtherExpress™ adapter Setup V4.16
View adapter configuration
Adapter type:.......................
Adapter part number:.............
Network address:..................
Interrupt:.............................
Bus:...................................
Slot:...................................
Device:...............................
Network speed:....................
Physical layer device:............
Duplex:...............................
Adapter capabilities:
100BaseTX, full or half duplex.
10BaseT, full or half duplex.
Press Enter to continue
Help = F1
Previous = Esc
LI6BM User's Manual
Chapter 9 LAN Driver Installation Guide
typing
in the DOS prompt, assuming
a:\setup
Main Menu
Action = ↵
will show the following.
Continue = Enter
PCI Advanced = F5
91