Chapter 11 Li6Bm And The Databook Case - TMC LI6BM User Manual

Chapter 11 LI6BM and the Databook Case

This chapter provides a step-by-step guide describing the procedure of
installing the LI6BM motherboard into its databook case. Carefully read
the instructions and follow the procedures one step at a time.
1. Removing top cover.
1-1. Remove the middle upper screw at the back of the case.
1-2. Slightly pull out the two clips on the two sides of the top cover.
Make sure the clips are now 'unlocked' before proceeding to the
next step.
1-3. Pull the top cover towards the back of the case by 2cm.
1-4. Remove the top cover in an upward direction.
Front
Panel
Edge
1-2
Back Panel
LI6BM User's Manual
Chapter 11 LI6BM and the Databook Case
FRONT
1-4
1-3
Pull 2cm
Pull up to
remove cover
1-1 Remove screw
1-2 Slightly pull
clip on both
sides
103