Boot Up Floppy Seek; Boot Up Numlock Status; Boot Up System Speed; Ide Hdd Block Mode - TMC LI6BM User Manual

Pentium ii/iii 440bx/apollo pro plus jumperfree motherboard
Table of Contents

Advertisement

Chapter 6 BIOS and System Setup

Boot Up Floppy Seek

When enabled, the BIOS will seek whether or not the floppy drive
installed has 40 or 80 tracks. 360K type has 40 tracks while 760K, 1.2M
and 1.44M all have 80 tracks. By default, this field is set to Enabled.

Boot Up NumLock Status

This allows you to activate the NumLock function after you power up the
system. By default, the system boots up with NumLock On.

Boot Up System Speed

This has no function and selects the default system speed (High).

IDE HDD Block Mode

This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.

Gate A20 Option

This field allows you to select how Gate A20 is worked. Gate A20 is a
device used to address memory above 1 MB. The default setting is Fast.

Typematic Rate Setting

When disabled, continually holding down a key on your keyboard will
generate only one instance. When enabled, you can set the two typematic
controls listed next. By default, this field is set to Disabled.

Typematic Rate (Chars/Sec)

When the typematic rate is enabled, the system registers repeated
keystrokes speeds. Settings are from 6 to 30 characters per second.

Typematic Delay (Msec)

When the typematic rate is enabled, this item allows you to set the time
interval for displaying the first and second characters. By default, this
item is set to 250msec.

Security Option

This field allows you to limit access to the System and Setup. The default
value is Setup. When you select System, the system prompts for the User
Password every time you boot up. When you select Setup, the system
always boots up and prompts for the Supervisor Password only when the
Setup utility is called up.
LI6BM User's Manual
41

Advertisement

Table of Contents
loading

Table of Contents