TMC LI6BM User Manual page 108

Chapter 11 LI6BM and the Databook Case
2. Removing the front panel section.
2-1. Remove the two flat-head screws on the two front corners of the
case.
2-2. Pull out the whole front panel section. The front panel section
has room for an FDD, HDD and CD-ROM drive.
2-1
Remove the
flat-headed
screw on
both sides
3. Installing the main components
3-1. Remove the riser card support by removing the screw from the
back panel.
3-2. Remove unnecessary I/O cover plates from the back panel.
Check the external I/O connectors on the motherboard to determine
which plates should be removed.
3-1
Remove the
screw to remove
the riser card
support
Back Panel
3-2 Remove unnecessary
I/O cover plates.
104
Pull out the whole
front panel unit.
2-2
Back Panel
3-3 Install the thin
LI6BM User's Manual
2-1
I/O panel plate
inside the
case.