TMC LI6BM User Manual page 82

Chapter 8 VGA Driver Installation Guide
8.3 Windows NT 4.0 Driver Installation
IMPORTANT: You should install the Windows NT 4.0 Service Pack 3
first before installing the ATI 3D RAGE LT PRO VGA drivers. If you
don't have the Windows NT 4.0 Service Pack 3, please contact your
software vendor or download it from Microsoft's web site.
Follows the steps below to proceed with the VGA driver installation for
Windows NT 4.0
Step 1. Run the Display program located in the Control Panel, under
Settings in the Start menu. Alternatively, position the cursor on
the background of the desktop, click the right mouse button, and
then select Properties from the popup menu.
Step 2. Select the Settings page.
Step 3. Select Display Type....
Step 4. Select Change... from the display options.
Step 5. Select Have Disk...
Step 6. Windows NT 4.0 will prompt you for the correct path. Enter
D:\VGA\LT-PRO\WINNT40 (if D: is your CD-ROM drive) or
A:\ (if you are using floppy diskettes)
Step 7. A list of ATI graphics accelerators will be displayed. Select ATI
Technologies Inc. 3D Rage LT Pro xxxx (xxxx refers to the
language.), and then click the OK button.
Step 8. Windows NT 4.0 will once again prompt for confirmation. All
appropriate files are then copied to the hard disk.
Step 9. Restart Windows NT 4.0. Windows NT 4.0 will start up using
the ATI drivers.
Step 10. NT 4.0 will boot into a default mode and start the Display applet
allowing for mode selection.
NOTE: If you select a color depth or resolution not supported by your
card, NT 4.0 will substitute 640x480 in 256 colors for the
display.
78 LI6BM User's Manual