Example #2 - extronics iSCAN100 Operating Manual

4.6.2 EXAMPLE #2:

The following example will set the scanner to the factory default settings, Disable
Scanning of Code 128 bar codes, change the beeper tone, and add a "G" as a
programmable prefix.
FEATURE
Enter Program Mode [stx]999999[etx]
Load Defaults
Disable Code 128
Alternate Tone 1
Prog. Prefix #1
Code Byte 0
Code Byte 7
Code Byte 1
Exit Program Mode
The scanner will beep three times!
The commands sent to the scanner do not include the small superscripted `3' that
you see in front of each bar code string in the MetroSelect manual. THE '3'
SHOULD NOT BE SENT, IT IS A CODE TYPE DESIGNATION ONLY!
As you will note for commands requiring additional bar codes to be scanned (such
as prefixes, suffixes, time-outs, etc.), simply send the code bytes in the same order
that you would normally scan the bar codes.
20
HOST ASCII REPRESENTATION
COMMAND
02h 39h 39h 39h 39h 39h 39h 03h [ack] or 06h
[stx]999998[etx] 02h 39h 39h 39h 39h 39h 38h 03h [ack] or 06h
[stx]100113[etx] 02h 31h 30h 30h 31h 31h 33h
03h
[stx]318565[etx] 02h 33h 31h 38h 35h 36h 35h 03h [ack] or 06h
[stx]903500[etx] 02h 39h 30h 33h 35h 30h 30h 03h [ack] or 06h
[stx]0[etx] 02h 30h 03h
[stx]7[etx] 02h 37h 03h
[stx]1[etx] 02h 31h 03h
[stx]999999[etx] 02h 39h 39h 39h 39h 39h 39h 03h [ack] or 06h
SCANNER
RESPONSE
[ack] or 06h
[ack] or 06h
[ack] or 06h
[ack] or 06h