4.4
Failure Modes
Flashing Green and one Raspberry Tone
This indicates the scanner has experienced a laser sub-system failure. Return
the unit for repair to an authorized service centre.
Flashing Red and Green with Two Raspberry Tones
This indicates the scanner has experienced a scanning mechanism failure.
Return the unit for repair to an authorized service centre.
Continuous Raspberry Tone with all LEDs off
If, upon power up, the scanner emits a continuous raspberry tone, then the
scanner has an experienced an electronic failure. Return the unit for repair to
an authorized service centre.
Three Beeps – on power up
If the scanner beeps 3 times on power up then the non-volatile memory
(NovRAM) that holds the scanner configuration has failed. If the scanner does
not respond after reprogramming, return the scanner for repair to an
authorized service center.
17
Need help?
Do you have a question about the iSCAN100 and is the answer not in the manual?