Table of Contents
Advertisement
Customising the system
It is possible to change the operation of the security
system to suit your requirements (see transmitter
learn procedure for details on how to enter the
software switches).
Once you have entered the software switch section
1. Press the GREY button on the transmitter to move
forward through the table to Switch 2 (two beeps
will be heard when the switch is selected).
Switch
Function
Number
Listen for the correct number of beeps and press both buttons to enter the software switch
1
Change siren tone
(eight tones available)
2
Full passive arming alarm/
passive immobiliser selection
3
Select engineer software switches
Changing the siren tone
1. Once you have found the siren tone selection
(switch 1), press both the GREY and BLACK
buttons of the remote control to select the
switch. A triple beep will be heard and the
siren will sound at a reduced volume.
2. Press the BLACK button on the remote control to
move backwards through the table to Switch 1
(one beep will be heard when the switch is
selected).
3. If 3 beeps are heard you have entered Switch 3
which requires a special engineer's code to enter.
Exit this area by pressing the GREY button to enter
Switch 1 again and wait for the confirmation beep.
Default
Method of altering setting/
setting
accepting setting
Siren 1
Sequential
GREY button = Next tone
BLACK button = Previous tone
BOTH Buttons = Accept tone
Off
GREY button/LED ON = Full passive alarm
BLACK button/LED OFF = Passive immobiliser
BOTH buttons = Accept arming method
Operable by installation engineer only
2. Each press of the GREY button will move the siren
tone forward to the next. If you press the BLACK
button you will return to the previous tone.
3. Once you have decided the siren tone you require
press both buttons of the remote control. When you
have selected it a double beep will be heard and
you will return to the software switch selection.
15
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the S4 and is the answer not in the manual?
Questions and answers
Hi. I have a bike which got unplugged from the t/charger causing a flat battery. The battery for the bike is ok now but the alarm initially kept going off then set,or so it seems. The alarm is not showing arming or disarming now. My bike can be started and the flashy light on the fob is working. Pls help?
To troubleshoot the Datatool S4 alarm system that is not showing arming or disarming after a flat battery:
1. Check the Fuses – Ensure all motorcycle fuses, including the alarm fuse, are intact.
2. Reset the Alarm – Disconnect the alarm system and reconnect it to reset.
3. Check the Wiring – Ensure all alarm connections are secure and no wires are damaged.
4. Use a Battery Conditioner – If the battery was disconnected, using a Datatool battery conditioner can help maintain the charge.
5. Check Ignition Sense – If the alarm does not respond even with ignition ON, verify that the alarm unit is receiving ignition sense.
6. Verify Kill Switch Position – Ensure the kill switch is in the ON position.
7. Reinstall Indicators Properly – If indicators were changed, ensure correct wiring to avoid alarm malfunction.
If the issue persists, contact your dealer for further assistance.
This answer is automatically generated