Table of Contents
Advertisement
Entering a new PIN code
To initialise the PIN number the following
procedure should be followed:
Ignition
ON
Press GREY button
To set
To set
first digit
second digit
One beep & flash
four beeps & flash two beeps & flash six beeps & flash
You can disarm the
alarm with the
transmitter at anytime
Changing your PIN
The PIN can be changed at any time simply by
repeating the above procedure. The original PIN will
be deleted and the new PIN will disarm the alarm.
NOTE:
1. The factory set PIN is 0000. This PIN will not
operate the alarm so it is important you set your
own personal PIN.
2. You cannot set a PIN without a valid remote
control. If you have no remote controls and do not
know the PIN, the system will have to be returned
to Datatool
®
for recoding and 2 new remote
controls. This is a chargeable service.
12
Ignition
Ignition
ON within
OFF
5 secs
ONE LONG TONE
To set
To set
third digit
fourth digit
DON'T WORRY IF YOU GET IT WRONG
If ignition is left OFF and
no action is taken within
3 minutes, the alarm will
revert to service mode
Press both buttons
simultaneously within 10 seconds
confirmation beep 3 secs
Repeat procedure to confirm new PIN
To confirm
To confirm
first digit
second digit
One beep & flash
four beeps & flash two beeps & flash six beeps & flash
New PIN
(3 long tones if incorrect confirmation)
3. If you do not set a PIN you will not be able to
disarm the system should you lose or damage
your remote control.
4. The PIN is also required to add further remote
controls or change the operation of the alarm via
the software switches.
5. Should you require your dealer to change any
settings or add a new remote control you should
inform them of your PIN. They will still be able to
carry out customisation of the unit but they will
have to over-write your existing PIN and you will
have to re-enter your preferred number.
Ignition
Ignition
OFF
ON
To confirm
third digit
TWO SHORT TONES
If ignition is left ON for
more than 10 seconds,
the alarm will revert to
disarmed mode
LED on bike
flashes rapidly
for 3 seconds
To confirm
fourth digit
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the S4 and is the answer not in the manual?
Questions and answers
Hi. I have a bike which got unplugged from the t/charger causing a flat battery. The battery for the bike is ok now but the alarm initially kept going off then set,or so it seems. The alarm is not showing arming or disarming now. My bike can be started and the flashy light on the fob is working. Pls help?
To troubleshoot the Datatool S4 alarm system that is not showing arming or disarming after a flat battery:
1. Check the Fuses – Ensure all motorcycle fuses, including the alarm fuse, are intact.
2. Reset the Alarm – Disconnect the alarm system and reconnect it to reset.
3. Check the Wiring – Ensure all alarm connections are secure and no wires are damaged.
4. Use a Battery Conditioner – If the battery was disconnected, using a Datatool battery conditioner can help maintain the charge.
5. Check Ignition Sense – If the alarm does not respond even with ignition ON, verify that the alarm unit is receiving ignition sense.
6. Verify Kill Switch Position – Ensure the kill switch is in the ON position.
7. Reinstall Indicators Properly – If indicators were changed, ensure correct wiring to avoid alarm malfunction.
If the issue persists, contact your dealer for further assistance.
This answer is automatically generated