Adding Extra Remote Controls; Removing Lost Or Stolen Remote Controls - Datatool S4 User Manual

Adding extra remote controls

All systems come with two remote controls pre-
programmed into the alarm unit. Should you require
extra or replacement remote controls they can be
purchased through any Datatool
You can have up to a maximum of 6 remote controls
operating the system at any one time.
To add a new remote control use the following
sequence:
a) Disarm the alarm system using either a
transmitter or PIN code (please note the code 0000
cannot be used, so if you have not previously
entered a PIN number and have lost both remote
controls the alarm unit will have to be returned to
Datatool ® to be cleared and have new remote
controls coded to it. This is a chargeable service).
b) Immediately after the LED flashes to signify the
number of remotes coded into it, turn the ignition
ON, OFF, ON, OFF and ON within 7 seconds.
c) The LED will enter rapid flash for 3 seconds and
then start flashing the LED slowly and beeping the
siren as previously described.
d) Enter the PIN number as previously described.
e) When the PIN number has been entered correctly,
the siren will give a long tone (1 second)
f) Immediately after the long tone turn the ignition
back ON.
g) Within 15 seconds press the GREY button on a
new transmitter to teach it to the system.
h) The LED will immediately flash with the number
of the remote control coded into the system (if
this is a new transmitter, the number will be the
total number of transmitters currently coded into
the system).
14
® authorised dealer.
i) Should you require more remote controls (or radio
linked PIR's) to be coded into the system, press the
GREY button on each transmitter required, leaving
no more than 15 seconds between presses
j) The transmitter memory is a stack with six locations
operating on a first in first out basis. There is no
limit to the number of transmitters which can be
taught at one time but the 7th transmitter/PIR will
replace 1st, 8th will replace 2nd etc.
k) Turn the ignition OFF and leave it OFF for 15
seconds to exit transmitter learn mode you will
hear, two long tones to indicate learn mode has
been exited.
l) Alternatively, if you want to enter the software
switches to customise the system to your
preferred settings turn the ignition OFF, wait for
two beeps and then turn it back ON (see next
section 'Customising the system').
Removing lost or stolen
remote controls
Lost or stolen remote controls can be removed from
your system by any APPROVED Datatool
Should you wish to exclude a remote control, take all
remaining transmitters (including any garage PIRs
coded into the alarm) with the machine to your
chosen dealer for them to carry out the service.
Your dealer may levy a small charge at their
discretion for this service.
NOTE: If you do not code in a remote control at this
stage, or find your lost transmitter, it can be simply
added by following the normal coding in procedure.
® dealer.