Touchmonitor Connections - Elo TouchSystems 2401LM Touchmonitor User Manual

Touchmonitor Connections

1. Connect the DVI or VGA video cables between the monitor's DVI/VGA input connectors and
your DVI/VGA video source, respectively. Tighten the video cable's screws for best
performance.
2. Connect the USB touch cable between the monitor's USB connector and your PC's USB port.
3. Connect the audio cable between the monitor's Audio In jack and your audio source.
4. Select the correct power cable for your region. Connect the cable between the AC power
source and the power adapter's input connector. Connect the power adapter's DC output
connector to the monitor's input power jack.
5. Be sure to reinstall the cable cover and secure with appropriate screws. Cables can be
routed inside the stand – remove and replace the stand cable cover for access and routing.
6. The Touchmonitor ships in an OFF state. Press the power button to turn it on.
© 2013 Elo Touch Solutions, Inc. All rights reserved.
User Manual 2401LM
SW200127 Rev A - Page 14 of 32