Oki OKIPAGE 10i Service Manual page 68

Page: 39
Service Manual - OKIPAGE10i
Chapter 3 Parts Replacement
(1) Remove the upper cover assy (see 3.3.1).
(2) Remove the operator panel assy (see 3.3.4).
(3) Remove the face up stacker assy (see 3.3.8).
(4) Remove the stacker cover assy (see 3.3.12).
(5) Remove four screws (1), lift and remove the fusing unit (2).
Caution: Fusing unit may be hot. Use care when handling.
Notes:
1. When reinstalling or removing the fusing unit, tighten or loosen the screws while holding the fusing unit
assy (2) down with your hand (it is being pushed up by back up roller).
2. When reinstalling the screws (1), be sure to direct the screws into pre-existing thread and avoid
damaging the threads.
3. Do not apply excessive torque when tightening the screws (1).