Oki OKIPAGE 10i Service Manual page 112

Category LCD status
message
Jam errors
Paper size
error
Service Manual - OKIPAGE10i
Chapter 6 Troubleshooting Procedures
Problem or status
A jam occurred during paper hopping
from the tray.
tray : TRAY1, TRAY2, FEEDER,
MANUAL
A jam occurred during paper feeding
after completion of paper hopping from
the tray.
tray : TRAY1, TRAY2, FEEDER,
MANUAL
tray : TRAY1, TRAY2, FEEDER,
MANUAL
Paper of improper size is being feed
from the tray.
tray : TRAY1, TRAY2, FEEDER,
MANUAL
Remedy
- Check the paper in the
cassette. Open and then
close the cover. When the
cover is closed recovery
printing is performed and
the error display is
released.
- If this error occurs
frequently, see Section
6.5.2 (2)-1.
- Open the cover, remove
the paper, then close the
cover. When the cover is
closed, recovery printing
is performed and the error
display is released.
- If this error occurs
frequently, see Section
6.5.2 (2)-2.
- Open the cover, remove
the paper, then close the
cover. When the cover is
closed, recovery printing
is performed and the error
display is released.
- If this error occurs
frequently, see Section
6.5.2 (2)-3.
- Check the paper in the
tray or check to see if
more than one sheet of
paper were being fed
simultaneously.
- Set the designated paper
in the tray.
- Open the cover, then
close it to perform
recovery printing and
release the error display.
- If this occurs frequently,
see Section 6.5.2 (3).
Page: 74