Paper Jam Detection - Oki OKIPAGE 10i Service Manual

The paper jam detection function monitors the paper condition when the power is turned on and during
printing. When any of the following conditions arises, this function interrupts the printing process. If any of
the following errors is encountered, printing can be recovered by removing the jammed paper (by opening
the upper cover, removing the jammed paper and closing the upper cover).
Error
Paper Input jam
Paper feed jam
Paper exit jam
Paper size error
Service Manual - OKIPAGE10i
Cause of error


The paper is in contact with the inlet sensor when the
power is turned on.


After hopping operation is attempted three times, the
leading edge of the paper does not reach
the inlet sensor.


The paper is in contact with the paper sensor when the
power is turned on.


The leading edge of the paper does not reach the
paper sensor within a predetermined feeding
distance since the paper has reached the inlet sensor.


The trailing edge of the paper does not pass over the
paper sensor within a predetermined feeding distance
after the same has passed over the inlet sensor.


The leading edge of paper does not reach the outlet
sensor within a predetermined feeding
distance after the paper has reached the paper sensor.


The paper is in contact with the outlet sensor when the
power is turned on.


The paper does not pass over the outlet sensor within a
predetermined feeding distance after the leading edge
of the paper has reached the outlet sensor.


The paper size check for manual feeding finds that the
paper size is free size.


The size of the paper is monitored by the inlet sensor 1.
The paper is not detected by the inlet sensor 1 within
predetermined feeding distance.


The inlet sensor 2 detects that the size of the loaded
paper is A4 or larger, or smaller than A4. The detected
paper size differs from the paper size set by command
or menu.


The paper size check for manual feeding finds that the
paper size is free size.
Chapter 2 Operation Description
Page: 18