Access From The Internet; Setting The Admin Password Over A Secure Connection - Vista VK2-540VRD User Manual

4. The encoder's Live View page appears in your browser.

3.2. Access from the internet

Access from the internet Once connected, the VK2-540VRD is accessible on your local
network (LAN). To access the VK2-540VRD from the Internet you must configure your
broadband router to allow incoming data traffic to it. To do this, enable the NAT-traversal
feature, which will attempt to automatically configure the router to allow access to the VK2-
. This is enabled from Setup > System > Network > NAT.
540VRD
For more information, please see NAT traversal (port mapping) for IPv4, on page 61.

3.3 Setting the admin password over a secure connection

To gain access to the product, the password for
the default administrator user must be set. This
is done in the "Admin Password" dialog, which is
displayed when the VK2-540VRD is accessed for
the setup at the first time. Enter your admin
name and password, set by the administrator.
Note: The default administrator username and
password is "admin". If the password is lost, the
must be reset to the factory default
VK2-540VRD
settings. See "3.9 Resetting to the factory default
settings".
To prevent network eavesdropping when setting the admin password, this can be done via
an encrypted HTTPS connection, which requires an HTTPS certificate (see note below).
To set the password via a standard HTTP connection, enter it directly in the first dialog
shown below. To set the password via an encrypted HTTPS connection, see Setup >
System > Secutity > HTTPS, on page 52.
15