Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Vista VK2-HDX20-SMW
Summary of Contents for Vista VK2-HDX20-SMW
- Page 1 Quick Installation Guide VK2-HDX20-SMW...
- Page 2 Please read this manual thoroughly before use and keep it handy for future reference.
- Page 3 1 Introduction The VK2-HDX20-SMW is a full HD H265 Vandal Resistant 20:1 zoom lens PTZ dome. It support alarm inputs and outputs and 2 way audio. The Dome can be powered via PoE or a separate 12VDC or 24VACpower supply Components This system comes with the following components;...
-
Page 4: Key Features
1.2 Key Features • Excellent video quality The network camera offers the highly efficient H.265 video compression, which drastically reduces bandwidth and storage requirements without compromising image quality. H.264 and Motion JPEG is also supported for increased flexibility. • Quad Streams The network camera can deliver quad video streams simultaneously using H.265/H.264 and Motion JPEG. -
Page 5: Installation
2 Installation 2.1 Mounting the Dome Camera The dome camera is for use in surface or pendent mounting applications, and the mounting position must be capable of supporting loads of up to 4.5 kg. (Pendent mounting must use pendent mount accessory.) The dome cameras mounting bracket should be attached to a structural object, such as hard wood, wall stud or ceiling rafter that supports the weight of the dome camera. - Page 6 CAUTION: Before installing mounting bracket to surface pre-adjust the four mounting screws “A” on the base of the dome camera to best match the mounting bracket locked position. Unscrew the locking screw on the side of the dome’s base and fit the tab of the mounting bracket into the locking slot.
-
Page 7: Basic Configuration Of Dome Camera System
2.2 Basic Configuration of Dome Camera System Type Description 3-PIN CAMERA POWER TERMINAL BLOCK (12VDC, 24VAC) A1: ALARM INPUT 1 A2: ALARM INPUT 2 A3: ALARM INPUT 3 6-PIN TERMINAL BLOCK A4: ALARM INPUT 4 G: GND AO: ALARM OUTPUT RJ-45 ETHERNET RCA BLACK... -
Page 8: Resetting To The Factory Default Settings
2.3 Resetting to the factory default settings To reset the network camera to the original factory settings, go to the Setup > System > Maintenance web page (described in “System > Maintenance” of User Manual) or use the Reset button on the network camera, as described below: •... - Page 9 2.4 Connections • Micro-SD Card Insertion User can install and change Micro-SD card as shown in the following picture. 1. Open the Micro-SD card cover. 2. Install or change Micro-SD card. 3. Close the Micro-SD card cover tightly to ensure waterproofing. •...
-
Page 10: Network Connection & Ip Assignment
2.4.1 Network Connection & IP Assignment The camera supports the operation through the network. When a camera is first connected to the network, it is necessary to allocate an IP address to the device with the SmartManager utility on the CD. - Page 12 VK2-HDX20-SMW Rev.A...