Resetting To The Factory Default Settings - Vista VK2-540VRD User Manual

3.10 Resetting to the factory default settings

To reset the VK2-540VRD to the original factory settings, go to the Setup > System >
Maintenance web page (described in "3.6.5.6 Maintenance") or use the control button on
the VK2-540VRD, as described below:
• Using the Reset Button
Follow the instructions below to reset the VK2-540VRD to the factory default settings using
the Reset Button.
1. Switch off the VK2-540VRD by disconnecting the power adapter.
2. Open the lens cover.
3. Press and hold the Control Button on the board with your finger while reconnecting the
power.
4. Keep the Control button pressed during about 2 seconds.
5. Release the Control Button.
6. The VK2-540VRD resets to factory defaults and restarts after completing the factory
reset.
7. Close the lens cover.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
70