Chapter 2 - Installation; Connecting Cables To Terminal Blocks - DFI KS200 User Manual

Chapter 2 - Installation

Connecting Cables to Terminal Blocks

Important:
When installing the touch panel PC, make sure the power is off. Failure to turn off, may cause
severe damage to the system.
1. Insert the cable end of the power adaptor to the terminal block. To firmly fix the cable into
the terminal block, use a screwdriver to clamp down the wires to the screw that is in the
terminal block
.
Terminal block
Wire
Power adapter cable
Chapter 2 Installation
Chapter 2
2. Plug the terminal block into the DC-in connector and then tighten the screws to secure the
terminal block in place.
DC-in
connector
+ -
White Wire
Black Wire
12
Screws
www.dfi .com