(for temperature and viscosity setting turn to page 9). MT2UL MT3UL Amps Model # Voltage Compressor Type of gas &...
Page 3
Lighted Top For light to be on top cover metal tab must touch the verticle wire. Verticle wire must touch flexible light contact on upper drip tray. To replace bulb and remove graphics remove screw from cover.
To Remove Scraping Blade & Auger Freezing Chamber Spiral Scraping Blade Magnetic Auger Gently turn scraping blade (clockwise) to disengage it from the auger. With one hand supporting the freezing chamber, pull the auger out. note: magnetic pull will be strong until the attraction is broken.
To Remove Bowl To Replace Bowl To properly fasten bowl, reverse each step by doing the following: Gently push bowl back and 1. Start with Step C, push forward up to unlock and firmly press down. the latch as shown in the 2.
To Remove Handle Assembly 1. Pull pin out. 2. Remove handle & spring. 3. Push faucet piston up from below and out of the bowl. Spring Handle Faucet Piston...
When Assembling Unit,The Following Must Be Lubricated •Faucet Piston• Lubricate both “O” Rings with Food Grade Lubricant •Magnetic Auger• Lubricate auger bushing. Lubricate nose of outer spiral.
Page 8
To Remove & Replace Rubber Gasket Remove rubber gasket by gently pulling gasket forward & around the freezing chamber. Replace gasket by gently pushing forward until gasket fits properly around gasket seat. *Do not use any lubricant on gasket.
Page 9
To Set 24hr. Defrost Timer: 1.Turn dial clockwise to set time of day. Align the current time of day with the white arrow on the timer face. 2. Program the defrost timer by pushing out on the white tabs that correspond to the hours desired to defrost.
SPARE PARTS PRICE LIST - MT UL MODELS DWG PART LIST DWG PART LIST DWG PART LIST DESCRIPTION PART # PRICE DESCRIPTION PART # PRICE DESCRIPTION PART # PRICE 00263 Transparent cover $ 40.00 Starting-run capacitor (chart) $ 120.00 00490 Flexible contact 00490 $ 14.00 00106 Bowl...
Page 12
Removal of Side Panel Remove left side panel by turning both thumb screws counter clockwise and pull off stainless steel shield. •Washable Filter• •Condenser• If placed next to another machine or object, allow 6” of space to provide ample air intake.