Configuring Vlan Translation - Zte ZXR10 8900 Series User Manual

ZXR10 8900 Series User Manual (Ethernet Switching Volume)
St- Command
ep
1
ZXR10(config)#
<session-no>{ethernet2| llc| snap}<0xHHHH> vlan
{<vlanId>|<name>}
2
ZXR10(config)#
3
ZXR10(config-if)#
disable}
4
ZXR10(config)#
Example
20 Confidential and Proprietary Information of ZTE CORPORATION
vlan protocol-map session-no
interface <interface-name>
vlan protocol-map {enable |
show vlan protocol-map
Note:
ZXR10 8900 series switch supports up to 16 protocol VLANs.
There are two data packets of different protocols in a client inter-
face fei_1/1 on a switch, 0X800 and 0X8100. It observes the two
packets respectively in another two interfaces fei_1/2 and fei_1/3.
Configuration on the switch:
ZXR10(config)#vlan protocol-map session-no 1 ethernet2
0x800 vlan 10
ZXR10(config)#vlan protocol-map session-no 2 ethernet2
0x7000 vlan 20
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#switchport mode trunk
ZXR10(config-if)#switchport trunk vlan 10,20
ZXR10(config)#exit
ZXR10(config)#interface fei_1/2
ZXR10(config-if)#switchport mode trunk
ZXR10(config-if)#switchport trunk vlan 10
ZXR10(config)#exit
ZXR10(config)#interface fei_1/3
ZXR10(config-if)#switchport mode trunk
ZXR10(config-if)#switchport trunk vlan 20
ZXR10(config)#exit
Configuring VLAN
Translation
To configure VLAN translation, perform the following steps.
Function
This configures protocol VLAN
function
This enters interface
configuration mode
This enables or disables a
protocol VLAN
This displays protocol VLAN
configuration information